Dinan Carbon Fiber Cold Air Intake for BMW 335is (E92/E93) (Dinan Part No. D760-0031)


Special Note: This kit requires the deletion of the auxiliary radiator in the front left of the car. A Dinan High Capacity Oil Cooler is required to maintain adequate engine cooling and warranty coverage.

As boost is increased through the use of performance software, the single factory intake becomes restrictive and the engine is lacking the air it needs to make maximum power. Our cold air intake force feeds the 3 liter turbocharged inline 6 with greater volumes of cool, oxygen rich air for substantial power gains by utilizing our secondary carbon fiber intake. The system is so effective that the carbon fiber inlet air temperature is a full 40 degrees Fahrenheit cooler than the incoming air from the stock inlet. Due to the increased airflow from our intake, the power-curve is extended into the higher RPM’s for a noticeable change. The system is a direct replacement for the factory air box lid, employing a hand-crafted carbon fiber unit that also includes a secondary carbon fiber intake tube that captures cool air from the lower grill and includes the shielding for the conical filter to insulate it from power robbing engine compartment heat.

Horsepower is increased by +14 Hp @ 6000 rpm and Torque is increased by +16ft-lbs @ 3400 rpm with Dinan Stage 3 Software, DINAN Intercooler and Free Flow Exhaust.

Stage 2 software, Free Flow Exhaust produces 12 Hp and 13 ft-lb torque Stage 1 software, Free Flow Exhaust produces 9 Hp and 10 ft-lb torque.

Completely Stock car produces 5 Hp and 6 ft-lb torque.

Additional information

Weight23.2 lbs
Dimensions36 × 24 × 12 in
Installation Hours


Emission Status

This product is in compliance with U.S. EPA Memorandum 1A, or this product has not been found, nor is believed to be, unlawful for use under the provisions of the Clean Air Act. Currently: This product is legal in California only for racing vehicles , which may never be used upon the highway.

Max HP Gain

14 hp @ 6000 rpm*

Max Torque Gain

16 ft-lbs @ 3400 rpm*

Included Notes

Carbon fiber lid, Carbon Fiber air intake tube, rubber hose coupler, Panel air filter for the airbox, Conical air filter for the secondary intake, shielding for the conical filter, Mounting brackets & hardware, Auxiliary radiator deletion kit.


There are no reviews yet.

Be the first to review “Dinan Carbon Fiber Cold Air Intake for BMW 335is (E92/E93) (Dinan Part No. D760-0031)”

Your email address will not be published. Required fields are marked *

2011 - 2013BMW335is (E92)3.0L L6
2011 - 2013BMW335is (E93)3.0L L6